Show Posts
1
General Discussion / Re: Allow Wan traffic to Lan
« on: May 03, 2021, 06:44:40 pm »
Hello,
I was facing the same issue, and i was able to fix it by adding a floating rule as follow :
Protocol : ICMP
Source: WAN net
Destination: LAN net
You can then add an other rule for the protocol you want to allow.
My outbound NAT is set to Hybrid, but i have no manual rules, so it's the same as automatic
Note that floating rules applied to every interfaces, so you don't have to repeat this rules on the WAN interface.
Hope it helps
Micmh4ck
I was facing the same issue, and i was able to fix it by adding a floating rule as follow :
Protocol : ICMP
Source: WAN net
Destination: LAN net
You can then add an other rule for the protocol you want to allow.
My outbound NAT is set to Hybrid, but i have no manual rules, so it's the same as automatic
Note that floating rules applied to every interfaces, so you don't have to repeat this rules on the WAN interface.
Hope it helps
Micmh4ck