1
19.1 Legacy Series / Re: Wireguard - multiple endpoints not in wg0.conf
« on: May 21, 2019, 10:22:01 pm »
Aaaand that was it.
Thanks, man, I appreciate it!
Thanks, man, I appreciate it!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
19.1 Legacy Series / Wireguard - multiple endpoints not in wg0.conf
« on: May 21, 2019, 09:45:58 pm »
Hi all, thanks for putting so much hard work into this project, it really shows.
I've got wireguard working on 19.1.8 (prod, but installed via CLI) and noticed that only one endpoint will populate into the wg0.conf -the first one I created. Even if I disable that first-created endpoint, no other will get into the .conf file.
If I manually populate the wg0.conf with the other peer entries it will load the additional config and work fine.
Is there a bug ticket system I should be putting this into, or is it known/fixed already and I just missed it since I'm not on the development build?
Thanks!
I've got wireguard working on 19.1.8 (prod, but installed via CLI) and noticed that only one endpoint will populate into the wg0.conf -the first one I created. Even if I disable that first-created endpoint, no other will get into the .conf file.
If I manually populate the wg0.conf with the other peer entries it will load the additional config and work fine.
Is there a bug ticket system I should be putting this into, or is it known/fixed already and I just missed it since I'm not on the development build?
Thanks!
Pages: [1]