Messages

From what i see on the floatint rules default deny action kicks it out. And i f i wanna make a rule i can not move above the default rules? so how i can disable this default rules?

i have a Mikrotik router as a core router for my internal lan where the all routing happens and aopnsense firewall for nat and internet.
From a mikrotik i go with a 172.x.x.x/30 to opnsense and all the routes from mikrotik are via 2nd gateway on opnsense to mikrotik router back routet routes are ok ping is ok but only when the mikrotik is in NAT mode if i disable natting on mikrotik i loose connection to the otherside. Mikrotik have as default route the opnsense. how i can make that without natting that i can reach internet and the opnsense self for monitoringß Thx for any help to make this happen.

Hi Wayne,
firstly thx for the help. The dns anounced from dhcp is the guest interface self via its ip there is no name given to the guest interface. If i use with certificate it is redirecting to this interface with certificate error because the routers certificate is private certificate, so no guest will have this certificate. I use it without SSl if it is so than the router not redirectings to it is interface. I can send you the config but where i can get it? is this the backup config?

Hi i am sorry no idea was hoping to get answer here but it seems that this project not so active from what i see here in forum. Pfsense was much active mybe i will switch to pfsense back again atleast there is much more community to can give some answer.

I setup a captive portal everything is fine and working but if you go to this network you get dhcp everyting is fine but you stuck in this link with timout for internet instead this not should be redirect to captive portal to login?