Messages

1

19.1 Legacy Series / Re: CRASH in 19.1.8 when PPPOE refreshes

« on: November 08, 2019, 02:04:28 pm »

The problem still persists on my machine 

As already mentioned here, the panic is often triggered when using the "disconnect/connect" buttons in the webgui. Furthermore, the same occurs when the cron job performs a "periodic interface reset". So, I disabled the related cron job to check, whether its more stable.

We have the same issue, any result on disabling the cron?

2

18.1 Legacy Series / Re: Multi Wan- switching GW

« on: January 22, 2019, 02:06:00 pm »

No, both WAN have static IP addresses

3

18.1 Legacy Series / Re: Multi Wan- switching GW

« on: January 22, 2019, 11:31:40 am »

18.1.2-2 -  still does not work

Next strange thing. I was add static route (Please correct me if I was this wrong). My steps:
1. Add Gateway (System - Gateway -> ALL -> Add ->  Serwer_OpenVPN )
2. Add Route (System -> Configuration -> Route
3. Add Firewall rule

When WAN ppoe is down and firewall option > Default gateway switching is enebled the routes looks:

Code: [Select]

ipv4 default 192.168.0.247 UGS 85 1500 em0 lan
ipv4 10.3.4.0/29 link#10 U 61557 1500 em0_vlan100 WAN2
ipv4 10.3.4.3 link#10 UHS 0 16384 lo0
ipv4 127.0.0.1 link#7 UH 49857 16384 lo0
ipv4 172.25.100.0/26 link#11 U 0 1500 em0_vlan10 MGM_ZONE
ipv4 172.25.100.1 link#11 UHS 0 16384 lo0
ipv4 172.25.101.0/26 link#12 U 69 1500 em0_vlan11 SRVALL_ZONE
ipv4 172.25.101.1 link#12 UHS 0 16384 lo0
ipv4 172.30.0.0/24 192.168.0.247 UGS 0 1500 em0 lan
ipv4 192.168.0.0/24 link#1 U 9290 1500 em0 lan

The default gateway set to Serwer_OpenVPN gate not to wan2. But on station internet goes through wan2 (Grupa_WAN).

Any update on this issue? I'm facing the same behavior. (18.7.10_3)