Messages

1

19.7 Legacy Series / Re: IPsec VPN not routing

« on: August 02, 2019, 01:02:08 am »

Same problem--I downgraded to 19.1, pn two OPNSense firewalls with routed IPSec vpn connections, got it working until a reboot, then my IPsec gw route disappeared on both ends and even if I re-enable, though I can get the IPSec link up, and can see traffic sent and received in logs, nothing shows up getting to the LAN hosts on either end. Very frustrating

2

19.7 Legacy Series / Re: After upgrade to 19.7 routing over IPsec tunnels seems broken

« on: July 31, 2019, 07:27:20 pm »

I have the same problem (I think) Tried to set up routed IPSec tunnel between two sites with 19.7.1 fresh install--set up Phase 1, Phase 2 on each box, Created pass-thru rules, a GW, set up route. As soon as I ran enable, both boxes were inaccessible via web gui (or from LAN side period).

Since it was a fresh setup, I set it up identically using PF-Sense 2,4,4 and it worked fine...I'd rather use OPNSense, but time is running out...

3

18.7 Legacy Series / No internet for dynamic DHCP assignment, internet works for static DHCP client

« on: December 30, 2018, 10:05:19 pm »

Any LAN DHCP client getting a dynamic DHCP assignment from the pool on boot will not have internet connectivity. but if I assign the MAC to a static mapping in OPNsense, Internet works.
I do not think there should be any difference (other than LAN address) between the two, but dynamic doesn't work, while a static mapping does...

I'm running 18.7.9