Messages

1

General Discussion / Port Forwarding

« on: September 18, 2018, 01:41:03 am »

Hi Guys. A newbie in Opnsense firewall and networking stuff. Still learning. Currently just switch from USG to Opnsense. I have to do a port forwarding for my cctv to do remote viewing. I input my own Dynamic Dyn already and did the required Port forwarding. It sort of works. However I’m facing this single issue. When I’m connected to my house WiFi, I can’t view it. But when I use my mobile data, I can view. Any advice where went wrong? My previous USG setup did not have this issue.


Sent from my iPhone using Tapatalk