Messages

1

24.1 Legacy Series / Re: Satellite OPNsense don't reconnect to main via Wireguard

« on: November 24, 2024, 08:46:01 am »

Running a similar setup.
Connectivity between remote clients and your wireguard instance should not fail after reboot of your equipment.
Is there traffic being forwarded constantly between these remote clients and you device?
Rgds

2

24.7 Production Series / Re: Multi WAN not working anymore

« on: November 24, 2024, 08:28:33 am »

If Opnsense is running as DNS Proxy, you should add a firewall rule in LAN interface allowing this packet.
This rule should be placed before the one defining the gateway.
Hope this helps

3

Hardware and Performance / Re: Mellanox Connectx3 QSFP+

« on: November 22, 2024, 08:51:07 pm »

Hi,
I would suggest to try fixing the media to the right speed of the interface.
Regards

4

French - Français / Re: NAT et régles

« on: October 31, 2024, 03:05:28 pm »

Bonjour,
Est-ce que la passarelle de l'équipement est bien le firewall?
Cdmt

5

Hardware and Performance / Re: Coaxial Modem

« on: September 28, 2024, 08:31:48 am »

Unfortunately to get internet through the coaxial network of Vodafone you need to get the modem from them as it needs to be activated from their end.

Tgds

6

24.7 Production Series / Re: i210 and SFP GPON Modul

« on: September 20, 2024, 07:54:03 am »

Most likely the SFP ONU will only activate when provisioned by the OLT, is this the case?
Please note as well that the SFP ONU might  not negotiate port speed, I would suggest to set the port speed to 1GBps ( or 2.5 Gbps).

Hope this helps 

7

General Discussion / Re: Speed limited when using 5G Modem as WAN

« on: September 20, 2024, 07:47:37 am »

I suppose you could use `ifconfig` in a shell to verify that your WAN interface really is connected at 2500Base-T. Beyond that, I can't think of anything.....

How do you configure the IP of interface both on the PC & Router?

Rgds

8

German - Deutsch / Re: public WAN von Gateway (Fritzbox) im Dashboard sehen

« on: September 20, 2024, 07:43:45 am »

Dyndns wäre mein Vorschlag.

G.

9

General Discussion / Re: Stateful PPPoE/CARP possible?

« on: September 08, 2024, 08:27:05 am »

Only if you add a third box doing the PPPoE termination. Otherwise the PPPoE connection needs to bounce between the two HA boxes in active/passive fashion.


Cheers,
Franco

Hi ,
Would a third Opnsense device as PPPoE termination a recommended option for this scenario?
Regards 

10

24.7 Production Series / Re: EETV and OPNSense Thriving Tiger - IPTV

« on: September 08, 2024, 08:16:30 am »

Hi,
to forward multicast traffic between  WAN and LAN interfaces, you will need to install and configure the igmp-proxy plug-in as well as the firewall rules on these interfaces.

This link might help:

https://docs.opnsense.org/manual/how-tos/dt_ger_iptv.html

Regards

11

General Discussion / Re: Streaming issues with OPNsense

« on: July 24, 2024, 11:24:37 am »

To streaming service on the  TV is some sort of app from your service provider or a standard OTT app such as Netflix, Youtube, etc?

Should the service stream using multicast traffic, IGMP proxy needs to be taken into consideration.

Hope this helps

12

General Discussion / Re: Streaming issues with OPNsense

« on: July 23, 2024, 10:46:53 am »

Hi there,

Is the video stream to the TV unicast or multicast traffic?

Rgds

13

24.1 Legacy Series / Re: Kea DHCP - High Availability/HA Setup/Migration

« on: June 11, 2024, 01:58:20 pm »

Found it,

from logs " 6 clients unacked so far, 0 clients left before transitioning to the partner-down state"

Thanks again for sharing.

14

24.1 Legacy Series / Re: Kea DHCP - High Availability/HA Setup/Migration

« on: June 11, 2024, 01:39:19 pm »

Thanks for sharing.

We am facing some difficulties in getting the backup server to start responding to dhcp clients on a test environment with just 5 clients. Sync running as expected.

Any tip would be appreciated.

15

23.7 Legacy Series / Re: DHCP Relay (multiple scopes)

« on: May 29, 2024, 06:59:18 pm »

Hi,

Just to confirm Kea does support the scenario.

Thanks for the info.