1
24.1 Production Series / Re: IPv6 stops routing a few minutes after boot
« on: April 25, 2024, 02:19:05 pm »
Just done a little further testing and important to note that when the IPv6 routing fails, I have also tried to ping from an IPv6 interface on the OPNsense firewall to an internet IPv6 address and the error I see is "No Route to Host"
Restarting routing service then allows the same ping set in the diagnostics from the firewall host to the Internet address to succeed with no losses so while I thought maybe it was just routing through from the LAN side to the internet that was failing, it appears the firewall host itself also cannot route to the IPv6 internet while in this state.
Thanks
Gareth
Restarting routing service then allows the same ping set in the diagnostics from the firewall host to the Internet address to succeed with no losses so while I thought maybe it was just routing through from the LAN side to the internet that was failing, it appears the firewall host itself also cannot route to the IPv6 internet while in this state.
Thanks
Gareth