Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - antcilli

#1
19.1 Legacy Series / Re: 19.1 Health Graph Reset
February 21, 2019, 02:57:15 PM
Wow, didn't realize the 'trash icon' next to each report was to flush that individual report. I saw the trash icon and assumed it was to 'remove' that data from being collected.
I just clicked the trash icon next to the '-quality' reports and the issue is resolved.
Thank you for the help!
#2
19.1 Legacy Series / 19.1 Health Graph Reset
February 20, 2019, 08:05:02 PM
I noticed in the migration notes for 19.1 it mentions a manual reset of the gateway health graphs may be necessary because of the apinger -> dpinger switch.
Is there a way to just reset the health graphs without resetting all of the other netflow data?
I did upgrade and noticed only the health graphs have stopped updating since the upgrade, so if it's possible avoid losing all of the other historical data, instructions would be greatly appreciated!
#3
Nothing major. Just went to add a new gateway to the configuration for some testing, and I put the name in as "2911" - quotation marks not included, to be clear.
The interface spits back this error: The name must be less than 32 characters long and may only consist of the following characters: a-z, A-Z, 0-9, _
If I update it to "2911_router", it goes through successfully. Not a huge deal, but it does appear there's an extra requirement for the name that isn't included. Not sure if it's a minimum length, or all numbers issue, but figured I'd point it out.  ;D

Currently running: OPNsense 17.7.9_9-amd64