Messages

1

17.7 Legacy Series / Re: Multi-WAN router-originated traffic

« on: August 17, 2017, 08:33:09 pm »

Hi Franco,
  thank you for your fast reply. Unfortunately the patch did not solve the problem. It made the situation slightly worse, because disabling interface OPT2 did change the default route back to OPT1, but router-originated traffic did not work again. I had to disable gateway OPT2 in addition to disabling the interface to get router-originated traffic work again. Do you need additional information from me? Shall i open a new thread?
best regards, Nikolaus

2

17.7 Legacy Series / Re: Multi-WAN router-originated traffic

« on: August 17, 2017, 12:16:38 am »

Hi,
  i might have a similar problem. I set up Multi-WAN for failover as described in the How-To using 17.7. Route and interface OPT1 is the default WAN set as Tier 1 (also set as "Default Gateway" in the gateway setting), Route and interface OPT2 is the backup Tier 2. The LTE-router at the backup interface is disabled, so only Gateway OPT1 is online. The "Gateway Switching" feature in Firewall > Settings > Advanced is off.
  All traffic LAN->WAN works as expected, but router-originated traffic does not work (e.g. check for updates does not work).
  Inspecting SYSTEM > ROUTES >STATUS i see the default destination for IPV4 set to OPT2, the disabled (non-default) gateway. Only when i disable the Interface OPT2 at the interface-settings, the default destination changes to OPT1 and router-originated traffic is working again.

best regards, Nikolaus