Messages

Ok thx a lot for your helps
So I delete IP of the test interface in 1.1.1.1, I correct the /32 in the mgmt

I disable the FW of both computer so it cannot block me ...
I put some floating rules on all the interface in any any and it's still the same
I can ping my passerelle in and out in 192.168.120.250 and 10.20.0.254 but not the computer in 23 ... it's my passerelle in that answer me :(
I also had in each interface a Rules any any  (Capure 4)
And it's the same from my other computer if I ping the 192.168.120.23 it's my passerelle in that answer me 10.20.0.254 but I can ping the passerelle out 192.168.120.250
I'm lost

Ok so we don't need to put a gateway on each interface ?
I remove all gateway and the 2 route that was a mistake indeed the 120.254 and 125.254
But still the same no ping answer from my computer but from the gateway

Hi everyone
I have set up a network with a switch whose ports are configured with tagged VLANs, two PCs on different subnets, and an OPNsense firewall, which I have configured with VLANs, interfaces, routes, and gateways. Attached are some screenshots.

From my PC, located on the LAN at 192.168.120.23, I am trying to ping my other PC at 10.20.0.23, but the response comes from the gateway (192.168.120.250) instead.

However, I can successfully ping my external gateway at 10.20.0.254, which responds correctly.
Additionally, from OPNsense, I can also ping 10.20.0.23 without any issues.
When I run a tracert, it only makes one hop to 192.168.120.254.

There is probably a missing configuration, but I can't figure out what it is.
I would appreciate your help.

Thank you!

Bonjour à tous
J'ai monté un réseau avec un switch dont les ports sont configurés en VLAN taggés, deux PC sur des sous-réseaux différents et un pare-feu OPNsense, que j'ai configuré avec les VLANs, interfaces, routes et passerelles. Ci-joint des captures d'écran.

Depuis mon PC, situé sur le LAN en 192.168.120.23, j'essaie de ping mon autre PC en 10.20.0.23, mais c'est la passerelle (192.168.120.250) qui répond.

En revanche, je peux bien ping ma passerelle externe en 10.20.0.254, qui répond correctement.
De plus, depuis OPNsense, je peux également ping 10.20.0.23 sans problème.
si je fais un Tracert il ne fait que 1 saut sur le 192.168.120.254

Il me manque probablement une configuration, mais je ne trouve pas laquelle. Je sollicite donc votre aide.

Merci !