Messages

1

General Discussion / Re: Multiple Public IP address - Use without NAT. (PPPoE multiple WAN blocks)

« on: May 05, 2024, 09:46:43 pm »

Hi Patrick,

Thanks. That configuration does work.

One issue left - Floating Rules / WAN Rules

The new interface, (assigned the /29), ultimately routes out of the WAN(PPPoE) gateway and is therefor impacted by floating rules assigned to the WAN(PPPoE) interface. I don't want the /29 to be impacted by some floating rule (e.g., GEO IP Block).

The only way I can think to fix this is by changing the destination for inbound rules from ANY to DEFINED SUBNET. And in reverse for the outbound rules. Thus excluding the /29 subnet.

Do you agree or have any better ideas?

Thanks
Josh
 

2

General Discussion / Multiple Public IP address - Use without NAT. (PPPoE multiple WAN blocks)

« on: May 05, 2024, 06:44:19 pm »

Desired Configuration:
Assign a host with one of the /29 public addresses directly without using NAT. Is this at all possible?

My Configuration:

ISP has assigned me a static /30 and /29 block.
ISP uses PPPoE (GPON Fiber from an ISP still living in the DSL era)

WAN Interface
iPv4 Configuration Type: PPPoE

I'm assigned the /32 ip address via PPPoE with the gateway of 10.10.10.15 (I assume this is the PPPoE server address on the ISP end.)

Virtual IPs:
I have configured the /29 block as an IP Alias under the WAN interface.


NAT, 1:1 NAT, and outbound NAT all function correctly using the /29 addresses.

Any help would be appreciated.