"
Hi All,
Let's say that i use it as the sole authentication database/method, then lose my phone. How can i recover? tia
Let's say that i use it as the sole authentication database/method, then lose my phone. How can i recover? tia
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
23.1 Legacy Series / Re: Traffic shaping based on L7 application, web URLs
February 17, 2023, 08:48:53 AM
just bumping the threat. tia
#3
23.1 Legacy Series / Traffic shaping based on L7 application, web URLs
February 15, 2023, 01:17:05 AM
Good day,
Seems that this feature was close to being available as of 2021:
https://forum.opnsense.org/index.php?topic=22958.0
Any updates on this? Currently using 23.1 and i can't find any page/tab/option for this.
tia
Seems that this feature was close to being available as of 2021:
https://forum.opnsense.org/index.php?topic=22958.0
Any updates on this? Currently using 23.1 and i can't find any page/tab/option for this.
tia
#4
Zenarmor (Sensei) / Zenarmor cannot detect OPT1, OPT2 interfaces
February 18, 2022, 12:11:48 PM
Good day!
i've been meaning to try it out, but am running into issues with the setup.
i currently have three interfaces on my test box: LAN, OPT1, OPT2. i was planning to run Zenarmor in transparent mode, with OPT1 and OPT2 as the bridged interfaces.
For some reason the Zenarmor setup cannot see OPT1 and OPT2. Suricata is disabled, both OPT1 & 2 are enabled under Interfaces, and they are not part of any bridge interface.
Any suggestions? Thanks
i've been meaning to try it out, but am running into issues with the setup.
i currently have three interfaces on my test box: LAN, OPT1, OPT2. i was planning to run Zenarmor in transparent mode, with OPT1 and OPT2 as the bridged interfaces.
For some reason the Zenarmor setup cannot see OPT1 and OPT2. Suricata is disabled, both OPT1 & 2 are enabled under Interfaces, and they are not part of any bridge interface.
Any suggestions? Thanks
Pages1
