"
After some googling, I found very few forum posts for "strongswan" which is what opnsense uses for IPsec. However I'm not aware if any of it applies to the situation. I searched on here before posting as well, with no luck.
I have a site-site tunnel working on this install with IPsec currently "con1" and everything is working great. I followed the steps to create a second VPN IPsec tunnel as I have on other opnsense setups, however on the "Status Overview" screen the VPN (con2) has an orange play button.
After I noticed that I started looking into the logs to find the lines that exist after trying to press the play button:
12[MGR] <con2|12> tride to checkin and delete nonexistent IKE_SA
12[IKE] <con2|12> unable to resolve %any, initiate aborted
12[CFG] received stroke: initiate 'con2'
I have tried recreating the VPN tunnel Phase 1 and Phase 2 with the same results. I'm hoping someone may be able to point me in the right direction to resolve the issue.
Cheers,
-Shawn
I have a site-site tunnel working on this install with IPsec currently "con1" and everything is working great. I followed the steps to create a second VPN IPsec tunnel as I have on other opnsense setups, however on the "Status Overview" screen the VPN (con2) has an orange play button.
After I noticed that I started looking into the logs to find the lines that exist after trying to press the play button:
12[MGR] <con2|12> tride to checkin and delete nonexistent IKE_SA
12[IKE] <con2|12> unable to resolve %any, initiate aborted
12[CFG] received stroke: initiate 'con2'
I have tried recreating the VPN tunnel Phase 1 and Phase 2 with the same results. I'm hoping someone may be able to point me in the right direction to resolve the issue.
Cheers,
-Shawn
