Show Posts
1
20.1 Legacy Series / ahcich0 CAM status: Command timeout after first reboot on 20.1
« on: February 04, 2020, 03:27:38 am »
System specs: Mini-Box M350/picPSU 80w, ASRock J3455B-ITX (Celeron J3455 1.5GHz), 6GB DDR3, 60GB SATA SSD, Intel PRO/1000 PT Dual Port NIC
Using Windows 10, I downloaded the latest VGA installer (OPNsense-20.1-OpenSSL-vga-amd64.img.bz2), extracted it, and then use Rufus in DD mode to write the image to a flash drive. I booted the Asrock PC to the flash drive to the live environment, and then installed OPNsense with no issue. After rebooting it came up fine and I began configuring a few port forwards and VLAN interfaces. Everything was going great.
Then after another reboot once it gets to the script carp_maintenance a ton of timeouts with SEND_FPDMA_QUEUED DATA SET MANAGEMENT come up: https://i.imgur.com/jsVR78W.jpg
I tried researching this a little bit and saw to change SATA mode in BIOS from AHCI to ATA, unfortunately this BIOS only lists AHCI mode. I've tried to disable S.M.A.R.T. in the BIOS but it still does this. The built in Realtek NIC is disabled. I also saw where adding the lines hint.ahci.0.msi="0" and ="1" into /boot/device.hints would fix it, but I'm not comfortable enough to try it or know if that would fix it anyway.
Any suggestions on this? I also wiped the SSD, ran the installer in UEFI mode, rebooted and ran the setup wizard. No additional interface config, vlans, firewall rules, services, etc... Rebooted and now it displays the same errors, but further down after it does Launching the init system...done. and Initializing..........done. Can't get to the web interface
Using Windows 10, I downloaded the latest VGA installer (OPNsense-20.1-OpenSSL-vga-amd64.img.bz2), extracted it, and then use Rufus in DD mode to write the image to a flash drive. I booted the Asrock PC to the flash drive to the live environment, and then installed OPNsense with no issue. After rebooting it came up fine and I began configuring a few port forwards and VLAN interfaces. Everything was going great.
Then after another reboot once it gets to the script carp_maintenance a ton of timeouts with SEND_FPDMA_QUEUED DATA SET MANAGEMENT come up: https://i.imgur.com/jsVR78W.jpg
I tried researching this a little bit and saw to change SATA mode in BIOS from AHCI to ATA, unfortunately this BIOS only lists AHCI mode. I've tried to disable S.M.A.R.T. in the BIOS but it still does this. The built in Realtek NIC is disabled. I also saw where adding the lines hint.ahci.0.msi="0" and ="1" into /boot/device.hints would fix it, but I'm not comfortable enough to try it or know if that would fix it anyway.
Any suggestions on this? I also wiped the SSD, ran the installer in UEFI mode, rebooted and ran the setup wizard. No additional interface config, vlans, firewall rules, services, etc... Rebooted and now it displays the same errors, but further down after it does Launching the init system...done. and Initializing..........done. Can't get to the web interface