Messages

I istalled it directly. It was pretty straight forward, no issue with the installation.
Downloaded the image, uncompressed it and used https://etcher.io/ to write it to USB flash drive.
Then, on the box, booted from the USB, ran the installer and that's it.

Well, solved the problem. Of course I can't set the LAN to 10.0.0.1/23 since 10.0.0.1 is the PPPoE Gateway IP.

Hello,

As you can see, I'm new around here. I don't have too much experience and knowledge, and not so much time researching everything. But I'll start this discussion, maybe some else finds it useful (as elektroinside said).

I'm tying to setup OPNsense on a box with GA Z370N-WIFI / i3-8100.
Setup needed:
- WAN - PPPoE
- LAN (to switch)
- 4G LTE modem (for failover)
- IPsec IKEv2 (CA cert auth)
- DHCP, DNS ...

Later on: IDS/IPS and other security improvements, WiFi Guest network(if it works)

The issue:
I've installed OPNsense (OPNsense-18.1-OpenSSL-vga-amd64). Changed the LAN IP with 10.0.0.1/23 and set the PPPoE credentials. Left other things as is.
The internet is not working from LAN, not even resolving the DNS, but I'm able to ping outside from the OPNsense box.
See ipv4 routes in the attached image.

Might it be something related to this(https://github.com/opnsense/core/issues/2186) issue? If yes, what can I do about it? :D