Messages

I do not have a remote management card.  :-[

I haven't changed anything, this was working properly until the power outage.

Any suggestions to check if the /boot/loader.* file is OK?

I have backup of the configuration, but not of the OSS.

Execute the command "fsck -y /" and it says that everything is fine with the FS!

Do you have any suggestions to run a diagnostic on the HDD?

I am not in the place where the hardware is.

Is possible to remotely run an OSS reinstall?

Thanks

Thanks for answering!

Pressing ENTER on this screen the OS starts up without problems and everything works normally!

The point is: avoid having to hit enter to start the firewall!

I suspect this fault was caused by a power outage!

Any ideas?

Good afternoon friends,

OS: 20.7.1

Problem: Is need to press ENTER to load the operating system.

Once ENTER is pressed, the system loads correctly.

What should I do to enable the system to boot automatically and unattended?

Thanks in advance.

Good afternoon friends,

Due to a serious hardware failure .. I had to recover my firewall from the backup on exactly the same hardware.

Everything is working fine, I exceed that I am experiencing a lot of packet loss. Ping is very unstable.

These messages are very repetitive:
Dec 21 17:16:26   kernel: pflog0: promiscuous mode enabled
Dec 21 17:16:26   kernel: pflog0: promiscuous mode disabled
Dec 21 17:16:09   kernel: pflog0: promiscuous mode enabled
Dec 21 17:16:09   kernel: pflog0: promiscuous mode disabled
Dec 21 17:16:01   kernel: pflog0: promiscuous mode enabled
Dec 21 17:16:01   kernel: pflog0: promiscuous mode disabled
Dec 21 17:15:44   kernel: pflog0: promiscuous mode enabled
Dec 21 17:15:44   kernel: pflog0: promiscuous mode disabled
Dec 21 17:15:42   kernel: pflog0: promiscuous mode enabled
Dec 21 17:15:42   kernel: pflog0: promiscuous mode disabled
Dec 21 17:14:28   kernel: pflog0: promiscuous mode enabled
Dec 21 17:14:28   kernel: pflog0: promiscuous mode disabled
Dec 21 17:13:48   kernel: pflog0: promiscuous mode enabled

Any idea how I can run a troubleshot to detect the source of the problem?

Friends,

I have installed and configured APSUPSD, but I don't know how to automatically load it when it starts opnsense.

Where should I place this command: apcupsd_enable="YES"

What is the exact path of the boot file?

Thank you!

Hello, OPNsense team!

Is it possible to use these blocklist as Firewall Aliases?
https://blocklist.site/app/dl/ads
https://raw.githubusercontent.com/StevenBlack/hosts/master/alternates/fakenews/hosts

Thank you

Good afternoon,

I have enabled the OpenVPN client on my local firewall. All internet traffic is routed to the internet through my OpenVPN Access Server in the cloud. This works correctly.

In my local firewall that works as an OpenVPN client, I have enabled the transparent proxy service with ssl inspection and cache. This is working with the particularity that web browsing traffic is not coming through the OpenVPN tunnel.

All web browsing traffic of the proxy service is coming out through the WAN interface.

How can I force this traffic to be routed via OpenVPN tunnel?

Diagram:
Lan >>> OpenVPN >>> Access Server >>> Internet (It works Ok - No proxy enabled)

Lan >>> Proxy >>> OpenVPN >>> Access Server >>> Internet (Doesn't Work proxy enabled)

What may be missing in my configuration?

Thanks in advance!