1
General Discussion / Multiple Public IP address - Use without NAT. (PPPoE multiple WAN blocks)
« on: May 05, 2024, 06:44:19 pm »
Desired Configuration:
Assign a host with one of the /29 public addresses directly without using NAT. Is this at all possible?
My Configuration:
ISP has assigned me a static /30 and /29 block.
ISP uses PPPoE (GPON Fiber from an ISP still living in the DSL era)
WAN Interface
iPv4 Configuration Type: PPPoE
I'm assigned the /32 ip address via PPPoE with the gateway of 10.10.10.15 (I assume this is the PPPoE server address on the ISP end.)
Virtual IPs:
I have configured the /29 block as an IP Alias under the WAN interface.
NAT, 1:1 NAT, and outbound NAT all function correctly using the /29 addresses.
Any help would be appreciated.
Assign a host with one of the /29 public addresses directly without using NAT. Is this at all possible?
My Configuration:
ISP has assigned me a static /30 and /29 block.
ISP uses PPPoE (GPON Fiber from an ISP still living in the DSL era)
WAN Interface
iPv4 Configuration Type: PPPoE
I'm assigned the /32 ip address via PPPoE with the gateway of 10.10.10.15 (I assume this is the PPPoE server address on the ISP end.)
Virtual IPs:
I have configured the /29 block as an IP Alias under the WAN interface.
NAT, 1:1 NAT, and outbound NAT all function correctly using the /29 addresses.
Any help would be appreciated.