1
24.1 Legacy Series / WAN speed is slow on APU2
« on: February 28, 2024, 08:13:38 pm »
Hello,
I updated my WAN connection to fiber, so now if I connect directly to the modem (in bridge mode) I get ~800 Mbps, but through the OpnSense it's only ~250 Mbps. My OpnSense installation is running on PcEngines APU2 board with 3xi210AT NICs.
One strange observation: in the interfaces widget (contrary to LAN and OPT1 where `1000baseT <full-duplex>` is displayed) nothing is shown for WAN (screenshot attached).
I'd appreciate very much any hints/ideas/etc.
Thank you.
I updated my WAN connection to fiber, so now if I connect directly to the modem (in bridge mode) I get ~800 Mbps, but through the OpnSense it's only ~250 Mbps. My OpnSense installation is running on PcEngines APU2 board with 3xi210AT NICs.
One strange observation: in the interfaces widget (contrary to LAN and OPT1 where `1000baseT <full-duplex>` is displayed) nothing is shown for WAN (screenshot attached).
I'd appreciate very much any hints/ideas/etc.
Thank you.