1
21.1 Legacy Series / Routing between interfaces and VPN
« on: July 30, 2021, 01:13:00 am »
I am a newbie with OPNsense and would appreciate your comments on this:
This is my setup:
ISP – OPNsense __ eth1 -- VPN -- LAN1 ... PC1, PC3
|__ eth2 -- WAN -- LAN2 ... PC2, PC4
|__ eth3 ...
OPNsense is permanently connected to VPN for LAN1 traffic. LAN2 goes thru OPNsense NAT to access the internet with my ISP public IP.
I needed computers from LAN2 to access computers in LAN1 (ssh, smb, nfs, etc) and vice versa
As all LAN1 traffic is sent to VPN, I tried creating a floating rule. Did not work
I think i may need to somehow 'route' only local traffic between (LAN1) 192.168.10.X and (LAN2) 192.168.20.X before it reaches the gateway for each interface: VPN or WAN.
Just not sure how. Any ideas are appreciated.
This is my setup:
ISP – OPNsense __ eth1 -- VPN -- LAN1 ... PC1, PC3
|__ eth2 -- WAN -- LAN2 ... PC2, PC4
|__ eth3 ...
OPNsense is permanently connected to VPN for LAN1 traffic. LAN2 goes thru OPNsense NAT to access the internet with my ISP public IP.
I needed computers from LAN2 to access computers in LAN1 (ssh, smb, nfs, etc) and vice versa
As all LAN1 traffic is sent to VPN, I tried creating a floating rule. Did not work
I think i may need to somehow 'route' only local traffic between (LAN1) 192.168.10.X and (LAN2) 192.168.20.X before it reaches the gateway for each interface: VPN or WAN.
Just not sure how. Any ideas are appreciated.