OPNsense Forum

Archive => 18.7 Legacy Series => Topic started by: guest19076 on September 28, 2018, 04:00:45 am

Title: Can't boot to install
Post by: guest19076 on September 28, 2018, 04:00:45 am

Trying to install, I created the USB boot stick with Rufus and the .img file. Upon boot it just hangs after showing the display resolution (see pic). Any ideas?

Title: Re: Can't boot to install
Post by: bartjsmit on September 28, 2018, 09:22:53 am

Do you have UEFI / Secure boot enabled in the BIOS?

Bart...

Title: Re: Can't boot to install
Post by: guest19076 on September 28, 2018, 07:46:02 pm

Quote from: bartjsmit on September 28, 2018, 09:22:53 am

Do you have UEFI / Secure boot enabled in the BIOS?

Bart...

It is an UEFI only motherboard (no legacy boot options) without a secure boot option (most likely due to lack of a TPM chip)

Title: Re: Can't boot to install
Post by: guest19076 on September 30, 2018, 06:30:48 pm

Went to try again today because I had found some steps that might help, and on first boot it hung after detecting USB devices then booted right up into the setup the 2nd time.

Didn't change anything, it just worked this time.  ???