OPNsense Forum

English Forums => General Discussion => Topic started by: slugstone on February 27, 2015, 06:16:01 am

Title: admin gui access from WAN
Post by: slugstone on February 27, 2015, 06:16:01 am

It seems I can access the admin GUI from my WAN address by default.  I would rather not be able to do this.  How do I disable this access?

Title: Re: admin gui access from WAN
Post by: franco on February 27, 2015, 08:26:55 am

You are probably talking about having it reachable from the LAN through the WAN IP. Try accessing from the WAN port: it does not work. Not even ICMP ping replies by default from there.

Title: Re: admin gui access from WAN
Post by: slackadelic on February 27, 2015, 02:18:39 pm

Outside access is disabled by default.  I had to create a specific rule to allow access to it from the outside world.

Title: Re: admin gui access from WAN
Post by: Lee Sharp on February 27, 2015, 05:15:36 pm

If you really want to you can try to create a block rule on the LAN interface to the WAN IP address.  I am not sure what would happen to traffic at that point, however, as it is a very odd configuration.