OPNsense Forum

English Forums => General Discussion => Topic started by: memeguy on July 24, 2018, 03:30:06 pm

Title: HELP - OPNSense Beginner
Post by: memeguy on July 24, 2018, 03:30:06 pm

I'm having a hard time configuring the network

When I connect to the input card the cable that comes from my wifi router the internet distribution works normally, but when I connect my link coming direct from the provider, it does not work, I have the settings but I do not know how to enter in OPNSense.

I need to reverse the order, first go through my firewall then go to the switch and router, not the router to my firewall

Title: Re: HELP - OPNSense Beginner
Post by: guest18611 on July 27, 2018, 12:42:13 pm

Hello memeguy,

when i understand you right, you must change your settigs in the WAN Interface in order to get your "provider cable" working.

I don't know your ISP Settings but you could try to go to Interfaces -> WAN and set the "IPv4 Configuration Type" to "PPPoE". Further down the Page you must enter your username and password from your ISP.