OPNsense Forum
English Forums => General Discussion => Topic started by: alvistar on October 07, 2017, 08:10:29 pm
-
Hi,
Is there any way to configure an interface to IPv6 autoconf and add some other fixed addresses through GUI?
This is quite easy to do by Shell but then I am not sure which other scripts will be affected.
Thanks in advance
-
Hi there,
Firewall: Virtual IPs can also add IPv6 unless I'm mistaken or there is a bug... :)
Cheers,
Franco
-
Hi,
I have checked and it looks like only IPV4 addresses are supported.
I can only choose /32 bit subnet. Am I missing something?
Like it's not easy to use ULA addresses.
a.
-
The UX is not perfect. You can input an IPv6. After save, the netmask goes up to 128.