OPNsense Forum
Archive => 17.7 Legacy Series => Topic started by: fabio on September 28, 2017, 08:32:02 pm
-
I've a couple of pfsense in HA configured also as OSPF router
Recently I've added an additional CARP address and both the device sterted to use this address as ospf router-ID so the "dynamic routing" stopped to works
... after change the ID via CLI the routing start to work again
root@OPN2:~ # vtysh
Hello, this is Quagga (version 1.2.1).
Copyright 1996-2005 Kunihiro Ishiguro, et al.
OPN2# configure terminal
OPN2(config)# router ospf
OPN2(config-router)# ospf router-id 192.168.0.3
OPN2(config)# write
Unfortunately after a reboot the ID retrun the old one
Is there way to permanently statically set the router-id ?
PS:
I'm not sure which was the IDs before the "new carp address" but the ospf worked fine
-
the router id is usually automatically generated and is afaik the lowest IP address of the router.
-
and no, I have not added that to the form, model and template so it currently does not work.
-
so should be possible add a new <ID> field in the form and insert
"ospf router-id <ID>" in /usr/local/etc/quagga/ospfd.conf
to obtain
router ospf
ospf router-id 192.168.0.3
passive-interface vtnet0
network 1.0.0.0/24 area 0.0.0.0
network 2.0.0.0/24 area 0.0.0.0
network 3.0.0.0/24 area 0.0.0.0
!
-
there's a patch now: https://github.com/opnsense/plugins/pull/299
opnsense-patch -c plugins 31ebef348199dc2dcfb3b3a35f7a88c26d8e7ec6
-
Thanks Fabian, it's perfect
Tested on my box it works like a charm
Thanks again for your works