OPNsense Forum
English Forums => General Discussion => Topic started by: ahmy on May 18, 2015, 11:00:16 pm
-
Still haven`t solved my first post yet and this secondary issue is ON already,
So far i have added an interface and assigned an IP addy for it, Sat DHCP server for Opt1 secondly i`ve created a firewall rule to allow traffic coming from my opt1 to the internet, connected my AP to opt1 interface no internet connectivity.
Cheers
-
Hey ahmy,
Might need some more information in order to solve this issue.
1. When you connect to the device are you getting an IP address.
2. If so are you able to ping the gate way from your wireless device .(ex. ping 10.0.0.1)
3. Next confirm that opt1 interface can reach the the internet. Go under Diagnostics and select ping, From ther put the following.
Host : 8.8.8.8
IP Protocol : IPv4
Source Address opt1
Count: 3
Please paste the results on your next update.
-
Hey ahmy,
Might need some more information in order to solve this issue.
1. When you connect to the device are you getting an IP address.
2. If so are you able to ping the gate way from your wireless device .(ex. ping 10.0.0.1)
3. Next confirm that opt1 interface can reach the the internet. Go under Diagnostics and select ping, From ther put the following.
Host : 8.8.8.8
IP Protocol : IPv4
Source Address opt1
Count: 3
Please paste the results on your next update.
Hey LordD,
Yes clients are able to get IPs i`v already sat a DHCP server for opt1, but i can not reach the internet surprisingly ping works under diagnostic PING
-
I think the issue might be with my Opt1 firewall rule here`s snap on my FW conf :
(http://i.imgur.com/b7FPs3Y.jpg)
-
Hello,
For your firewall rules what happens whe you change your destination to any or Wan net. Are you able to reach the Internet then.