OPNsense Forum

Archive => 17.1 Legacy Series => Topic started by: Pimmal on February 06, 2017, 11:03:26 pm

Title: [Solved] Multi WAN Problem
Post by: Pimmal on February 06, 2017, 11:03:26 pm

I have installed 17.1 and now multi wan is not working.
I have one DSL line and one LTE line.
In the systemd efault gateway is DSL and always the traffic is routed over DSL gateway.
If i set in firewall for the * all rule gateway LTE then the traffic is again routed over DSL gateway.
WHY???

Title: Re: Multi WAN Problem
Post by: franco on February 07, 2017, 08:47:26 am

Hi Pimmal,

Use this kernel... We are addressing this issue with 17.1.1 on Thursday.

# opnsense-update -kr 17.1-route
# /usr/local/etc/rc.reboot


Cheers,
Franco

Title: Re: Multi WAN Problem
Post by: Pimmal on February 09, 2017, 05:36:15 pm

Problem still persists on 17.1-1 and i have another problem form time to time https sites are not loading in case of tehy have the certificate from the web configurator.

Title: Re: Multi WAN Problem
Post by: franco on February 09, 2017, 08:03:05 pm

On 17.1.1 try setting the sysctl for the old routing behaviour:

# sysctl net.pf.share_forward=0

If the problem persists, was it verified and working on a 16.7.14? If not, it could be a setup issue.


Cheers,
Franco

Title: Re: Multi WAN Problem
Post by: Pimmal on February 09, 2017, 08:15:08 pm

Was working on 16.7.14 i try now a clean install and will report here again after configuring.

Title: Re: Multi WAN Problem
Post by: Pimmal on February 09, 2017, 10:30:56 pm

Was a config Problem "sticky connections"

Title: Re: Multi WAN Problem
Post by: bulmaro on February 10, 2017, 05:10:32 pm

Quote from: franco on February 09, 2017, 08:03:05 pm

On 17.1.1 try setting the sysctl for the old routing behaviour:

# sysctl net.pf.share_forward=0

If the problem persists, was it verified and working on a 16.7.14? If not, it could be a setup issue.

Cheers,
Franco

It is actually solved, but when the restart is erased the configuration, how to leave it permantente?
Thank you for your attention

Title: Re: [Solved] Multi WAN Problem
Post by: Pimmal on February 10, 2017, 05:24:44 pm

For me it was solved, because on my side in the config were marked sticky connections.

Title: Re: [Solved] Multi WAN Problem
Post by: franco on February 10, 2017, 07:26:48 pm

bulmaro, you can add this setting to the System: Settings: Tunables section.

Title: Re: [Solved] Multi WAN Problem
Post by: bulmaro on February 13, 2017, 04:46:42 pm

Add the following configuration, did no effect

Title: Re: Multi WAN Problem
Post by: exaper on February 13, 2017, 07:08:37 pm

Quote from: franco on February 07, 2017, 08:47:26 am

Hi Pimmal,

Use this kernel... We are addressing this issue with 17.1.1 on Thursday.

# opnsense-update -kr 17.1-route
# /usr/local/etc/rc.reboot


Cheers,
Franco

How can we upgrade/install 17.1.1? FW downloads page still point to 17.1