OPNsense Forum
English Forums => Tutorials and FAQs => Topic started by: NetworkNoob on January 26, 2024, 06:29:26 pm
-
I am trying to set up multiple privacy VPN clients.
(Same VPN provider, just using different endpoint servers for my main LAN and Guest network)
I have a 4-port Protectli vault, single WAN. I have successfully set up an outbound VPN on my main LAN. I duplicated the same process for a VPN client on the guest network, on the OPNSense dashboard all indicators are green and I have a second VPN IP address showing. However, the machine on that guest interface does not get internet connectivity. If I switch the NAT rule on the guest network to use the same OpenVPN interface as the main LAN everything works.. cant figure out where I am going wrong.
Are there any good guides that would address a setup like this?
-
Now you shouls create NAT rules to forward all/part of your traffic through those tunnel interfaces.
Hope this helps
-
Yes, I have outbound NAT rules. However, only 1 of the VPN connections ever works at a time. I have yet to get them both working at once. I do the exact same process for both. Once for my main network and once for the guest network. Everything except the Source interface is identical in the NAT rule.
I have no idea where I am going wrong.
-
Hi there,
Not clear what your traffic plan should look like.
Yor plan is to forward traffic from your LAN through tunnel1 and traffic from your GUEST network through tunnel 2, right?