OPNsense Forum
Archive => 22.1 Legacy Series => Topic started by: C4r1s on April 05, 2022, 06:00:38 am
-
Gday,
When I use Opnsense under proxmox it seems under any browser configuration changes constantly appear to be loading on the page and never complete in lan/wan (card is a passed through t350 2 port intel). Refreshing the page usually shows the action as completed.
However sometimes on refresh, I lose access to the ui.
My system is a 8th gen intel, vt-d enabled, tried with both sriov enabled and disabled. Qemu agent installed does nothing.
Settings on vm is a q35-3.1 (have tried default), have tried kvm and host cpu settings etc. qemu set on proxmox and have set network cars as pcie.
Any ideas appreciated, thank you
-
Just a lucky guess but try to enable "promiscuous mode" in settings of the Interface(s)
I had the same issue with VLANS, Page Loads sometimes partially, but never completely
-
I got this to work, I don't know exactly what I changed that fixed it.
Thanks for the advice above, i'll keep that in mind should I run into this again.
I re-flashed bios and there's been an opnsense update since my last post, might have been fixed there.
Thank you