OPNsense Forum

Archive => 21.1 Legacy Series => Topic started by: clarknova on August 26, 2021, 05:43:37 pm

Title: Shaper: pipe in pipe?
Post by: clarknova on August 26, 2021, 05:43:37 pm
I've read the documentation and played with the shaper some, and it appears there's no way to create a pipe inside a pipe. Is that correct or did I miss something?

I haven't tried in 21.7 yet, just the 21.1 series.
Title: Re: Shaper: pipe in pipe?
Post by: tong2x on September 08, 2021, 02:41:36 am
A pipe with a pipe?
or rather priorities or queues?

if you look at queue it may look similarly to a pipe(not a pipe but similar), say a 100mbps pipe
at for http you can set 20% of the bandwidth or whole bandwdith.