OPNsense Forum
English Forums => Hardware and Performance => Topic started by: cwesterfield on July 12, 2021, 04:45:39 pm
-
I have a Supermicro box (OPNsense 21.1.8_1) with an HP branded 10G card.
I used the boot flag if_oce_load="YES" to get the box to see the two interfaces.
When there are no VLANS running through the 10G, it works great. If I add one, it starts a reboot cycle.
Does that mean the card is incapable of vlans, has bad firmware, or maybe some other thing I don't know about?
Output of pciconf -lveV
oce0@pci0:4:0:0: class=0x020000 card=0x1747103c chip=0x070019a2 rev=0x02 hdr=0x00
vendor = 'Emulex Corporation'
device = 'OneConnect OCe10100/OCe10102 Series 10 GbE'
class = network
subclass = ethernet
PCI-e errors = Correctable Error Detected
Unsupported Request Detected
Corrected = Advisory Non-Fatal Error
oce1@pci0:4:0:1: class=0x020000 card=0x1747103c chip=0x070019a2 rev=0x02 hdr=0x00
vendor = 'Emulex Corporation'
device = 'OneConnect OCe10100/OCe10102 Series 10 GbE'
class = network
subclass = ethernet
PCI-e errors = Correctable Error Detected
Unsupported Request Detected
Corrected = Advisory Non-Fatal Error
$ sysctl -a | grep oce | grep ion
net.inet.ip.process_options: 1
dev.oce.1.firmware_version: 4.9.416.2
dev.oce.1.component_revision: ///11.0.50.0///
dev.oce.1.%location: slot=0 function=1 dbsf=pci0:4:0:1
dev.oce.1.%desc: Emulex CNA NIC function:///11.0.50.0///
dev.oce.0.firmware_version: 4.9.416.2
dev.oce.0.component_revision: ///11.0.50.0///
dev.oce.0.%location: slot=0 function=0 dbsf=pci0:4:0:0
dev.oce.0.%desc: Emulex CNA NIC function:///11.0.50.0///
-
I don't have any experience with this particular card, but have you tried changing the hardware offloading settings? They are in Interfaces -> Settings. Hardware offloading is known to generate erratic behavior in cards with mediocre drivers. Not this saying this the case here, but it wouldn't hurt to try out.