OPNsense Forum
English Forums => Hardware and Performance => Topic started by: Solid-Profession on May 10, 2021, 12:17:19 am
-
Hi
I've just got my Qotom box now, but I'm not sure how you install opnsense on here? Also, do I have to mess around with jumpers?
Thanks
-
boot usb stick and install
-
boot usb stick and install
Don't I need to do anything with the jumper? Or also with the thermal paste and heatsink?
-
the jumper is so that it reboots after powerloss, that have nothing to do with installing
i havent done anything with "thermal paste and heatsink", works fine anyway
-
the jumper is so that it reboots after powerloss, that have nothing to do with installing
i havent done anything with "thermal paste and heatsink", works fine anyway
Thanks! I've had a look on YouTube how to do that, and that seems to have helped me with that bit
I might get a USB Noctua fan, to put on the outside to help cool it down too
-
boot usb stick and install
I've run a Qotom i7 box for the past 2 years with factory paste no issues at all.
-
the jumper is so that it reboots after powerloss, that have nothing to do with installing
i havent done anything with "thermal paste and heatsink", works fine anyway
Thanks! I've had a look on YouTube how to do that, and that seems to have helped me with that bit
I might get a USB Noctua fan, to put on the outside to help cool it down too
sure you could put a usb fan, easy job to try
but unless it´s hot where it sits or wery heavy loads it shouldent be needed with a fan
-
I have one of these boxes too. Keep in mind that the physical order of network ports is different than in the software, the ports are numbered 0 2 3 1 IIRC.