OPNsense Forum
English Forums => High availability => Topic started by: andrema2 on January 20, 2021, 09:09:37 pm
-
Hi all
I'm trying to setup 2 OpnSenses 2.7.8 as HA. To be able to work I had to add a rule at the slave SYNC interface FW to allow all IPV4 incoming. I did the same on the MASTER.
As I sync it, this rule gets delete on the SLAVE and from them on it doesn't allow the sync to happen again. If I add the rule on the SLAVE it syncs but at the end the rule is deleted.
What am I doing wrong ?
-
So I just figure it out.
If you don't assign the interface during install or via telnet menu they get named something different. Then they don't match.
Once I went back and did it via telnet menu, the names were corrected and it completed ok