OPNsense Forum

Archive => 20.7 Legacy Series => Topic started by: tofaz on November 10, 2020, 04:46:58 pm

Title: Shaper not showing IPs/subnets in the status active flows
Post by: tofaz on November 10, 2020, 04:46:58 pm

Hey Guys,

Does any of you is experiencing the same issue where the shaper status is not showing IP address/subnets details in the active flows?

Should it shows the details about the socket that is using that flow? In my case it's always 0.0.0.0/0 for all active flows as per the screenshot attached.

Thank you!
tofaz

Title: Re: Shaper not showing IPs/subnets in the status active flows
Post by: tofaz on November 12, 2020, 02:47:04 pm

Up

Title: Re: Shaper not showing IPs/subnets in the status active flows
Post by: dinguz on November 12, 2020, 03:13:32 pm

Might be related to this:

https://forum.opnsense.org/index.php?topic=19119.msg87587#msg87587

Title: Re: Shaper not showing IPs/subnets in the status active flows
Post by: tofaz on November 12, 2020, 06:24:38 pm

Thank you!

It looks like there have not been any update since July.