OPNsense Forum

Archive => 20.1 Legacy Series => Topic started by: bobpaul on August 09, 2020, 05:01:42 am

Title: Can't upgrade to 20.7 after restore with beadm
Post by: bobpaul on August 09, 2020, 05:01:42 am

I used beadm to take a snapshot, then I upgraded to 20.7. I'm pretty sure it was successful, but I guess I didn't pay too much attention.

Then I messed around with some bridge settings and locked myself out from the network. I used the local VGA console and used beadm to restore to prior to the upgrade. Things were working, so I deleted the broken 20.7 boot environment; figured I could just upgrade again.

Well now when I go to System -> Firmware -> Upgrade it claims no upgrades available. It doesn't show the 20.7 unlock button.

If I do Audit -> Health it shows a ton of checksum mismatches. I don't think that was the case before I attempted the upgrade, etc.


Is it possible that the something from 20.7 survived switching beadm to switch boot environments back to 20.1?

see: https://controlc.com/9c26862d

Code: [Select]

$ uname -a
FreeBSD router.local 11.2-RELEASE-p18-HBSD FreeBSD 11.2-RELEASE-p18-HBSD  f08b5f14327(stable/20.1)  amd64
No issues turned up in zpool scrub.