OPNsense Forum
Archive => 15.7 Legacy Series => Topic started by: aspire78 on November 06, 2015, 12:34:56 pm
-
Hello
I have one interface dedicated to LAN and other one for my lan test called OPT.
I want to block/reject traffic from lan to opt and opt to lan.
I trayed with firewall rules but i can still ping form lan to opt.
Any ideas ?
Thank you
Best regards
-
It's OK now ..
i think that i should wait some minutes that rules refresh
:o
-
Hi there,
Make sure the block LAN->OPT1 rule in the firewall: rules; LAN tab are above the automatically generated IPv4 and IPv6 pass rules. Happens to me too sometimes...
Cheers,
Franco