OPNsense Forum

English Forums => Hardware and Performance => Topic started by: andycrawford on September 03, 2019, 07:09:13 pm

Title: Marvell 88E6190 embedded network switch hardware
Post by: andycrawford on September 03, 2019, 07:09:13 pm

Anyone with experience working with router boards with the integrated Marvell 88E6190 or similar series network switches? I have worked with them quite a bit on pfSense, currently have a few with pfSense on them and would love to move over to using opnsense on them but a little concerned about switch and VLAN configurations of the switch after move.

Is the software interfaces exposed on opnsense to manipulate the VLAN configuration on the ports of the switch?
If not, is the userspace interface exposed to configure a direct attached switch via console?

Thanks much...

Title: Re: Marvell 88E6190 embedded network switch hardware
Post by: smarshed on December 26, 2019, 07:06:52 pm

Did you ever figure out an answer to this? I was wondering the same thing exactly!

I bought an XG-7100 (from NetGate https://store.netgate.com/XG-7100.aspx) without checking for non-pfsense support. I don't hate pfsense, but I'd like to try other OSes.

Title: Re: Marvell 88E6190 embedded network switch hardware
Post by: whitelizard on February 05, 2020, 02:40:12 pm

I would be really interested in an image for RPi4!