OPNsense Forum
Archive => 19.7 Legacy Series => Topic started by: janne on August 20, 2019, 01:54:43 pm
-
Hi.
Attempting to install a new Gateway but it will not enter the list.
It shows up in services but that's all.
What to do? Grateful for help solving this.
Ver. 19.7.2
-
Did you set ip dynamic while interface is static?
-
I've already done this on two devices but that was before updating to 19.7.2.Now I have tried a unit that already has two gw and tried to add a third but it does not work. Must be something that is not ok in ver.19.7.2.
-
I just tried reinstalling with ver. 19.7 and then everything works fine.It works perfectly ok with posting moreGW under systems and they appear in the list but not in ver. 19.7.2.
-
It seems to work if you use IPv6 but if you only use IPv4 nothing is displayed and cannot be configured.
-
Can we make this work as soon as possible?
Need this to configuure the Failover gateways and the way it is now, it doesn't work anymore.
Major problems.
-
You can always revert to 19.7.1 if it's urgent. Just search the docs for opnsense-tools
-
Ok, thanks.
I've read, but I don’r really understand how to do it to go back to 19.7.1.
-
opnsense-revert -r 19.7.1 opnsense
-
Ok, but where do I put this in?
I'm sorry I m a little novice in this.😊
-
Via console/SSH
-
Hi and thanks for all the help. Have learned a lot because of this problem.
Think I did a little wrong myself. Installed 19.7.1 and everything works.
Thanks mimugmail!
/ Janne :)
-
Can you try with 19.7.3 (when released) and report back? Otherwise you can restore again :)
-
:) ;)
-
:)
Hi.It worked better with 19.7.3.
Now you can see the Gateways that you created and couldn't remove that probably created the problems.
Have still problems to make failover to work but that is in an other tread.