OPNsense Forum
Archive => 19.7 Legacy Series => Topic started by: gbulfon on July 18, 2019, 05:41:04 pm
-
Hi, I'm getting mad making IPsec to work correctly.
I have configured a VPN from an OPNsense 19.7 public machine to a customer public firewall.
The VPN goes up, but then no ping is possible between the two private networks.
I discovered that from the OPNsense side, pinging a remote machine, packets goes out of the WAN, instead of being routed into the IPsec tunnel.
Looks like the routes are not installed.
I found this link, where someone had the same problem:
https://www.reddit.com/r/OPNsenseFirewall/comments/b6gzz4/ipsec_tunnel_routes_not_installed/
Tried running "ipsec route con3", but not working.
Also, it would be a mess to need to run these routes installs manually for every VPN I need to manage.
Any idea?
-
Same problem--I downgraded to 19.1, pn two OPNSense firewalls with routed IPSec vpn connections, got it working until a reboot, then my IPsec gw route disappeared on both ends and even if I re-enable, though I can get the IPSec link up, and can see traffic sent and received in logs, nothing shows up getting to the LAN hosts on either end. Very frustrating
-
Do you have auto nat for outbound nat enabled? Yesterday therecwas acguy with the same issue and settings to manual fixed it ( with adding the usual stuff )