OPNsense Forum
Archive => 19.7 Legacy Series => Topic started by: netgeek on July 13, 2019, 08:52:15 am
-
I have a working Routed IPSEC (VTI) tunnel that has a IPv4 phase 2 that works fine. I'd like to add an IPv6 routed phase 2, but when I try to enter IPv6 addresses I get:
The following input errors were detected:
A valid local network IP address must be specified.
A valid remote network IP address must be specified.
Is there any plan to support IPv6 routed IPSEC?
-
It looks like there is an issue with "tunnel ipv6" mode as well. If you choose Local Network: Network and try to fill in an address, you are limited to /0 - /32 as a subnet mask.
-
A fix will be in 19.7 as https://github.com/opnsense/core/commit/c3ccc63fd
However, if you want to make sure your reports will make it into a release please use GitHub instead for specific reports:
https://github.com/opnsense/core/issues/new/choose
Cheers,
Franco