OPNsense Forum

English Forums => General Discussion => Topic started by: floschn on May 17, 2019, 09:29:54 am

Title: Multi WAN question
Post by: floschn on May 17, 2019, 09:29:54 am

Hello,

i would like to switch to OPNSense. The only thing that i couldn't find in the documentation is a Multi WAN question.

I only see LoadBalancing / Failover in the documentation. But is it possible that i split up 2 LAN and 2 WAN line to each other without failover / Load Balancing? So that LAN1 uses only WAN1 and LAN2(&3) only uses WAN2. Is that possible? i assume it is wenn i do configure Manual NAT for all the Networks. But before i try i just wanted to know if it is possible.

Thanks

Title: Re: Multi WAN question
Post by: daigoro on May 17, 2019, 12:12:15 pm

Hello,

it is possible.
You simply need to configure the proper WAN Gateway (WAN1 or WAN2) to a rule belonging to your LAN interface.

Title: Re: Multi WAN question
Post by: floschn on May 18, 2019, 10:39:04 pm

TY