OPNsense Forum
Archive => 19.7 Legacy Series => Topic started by: hboetes on April 03, 2019, 11:02:55 am
-
Hi there,
We were already using OPNsense as a VM and have now bought a hardware appliance. Of course the VM was not set up with a full trunk, but with separate interfaces, for each VLAN one interface.
The appliance obviously becomes a trunk and will get VLANs as network interfaces.
Is this a problem when setting up a HA and config synchronisation?
-
No, but when interface drivers are different the state sync will not work properly