OPNsense Forum

English Forums => General Discussion => Topic started by: walkerx on March 28, 2019, 10:38:02 am

Title: Remove Double-Nat help needed
Post by: walkerx on March 28, 2019, 10:38:02 am
Hi,

I have opnsense configured on a 10.x.x.x range for all my wired devices

I have Google Wifi installed in router mode to make use of the mesh network (as some of the units are in areas that can't be hardwired back) - the google wifi gets it's ip on the wan for 10.x.x.x range and then allocates the range 192.x.x.x to its clients.

Is there a way of enabling the google wifi to provide addresses within the same range as the wired devices

And is there a way of getting IPv6 addressing through to the Google Wifi so it can allocate IPv6

I have a static ipv6 setup and isp provided range /64 (wan) and /48 (local) - my wired devices are receiving their ipv6 details, but would like to get this on the wifi devices as well
Title: Re: Remove Double-Nat help needed
Post by: bbin on August 08, 2020, 05:40:59 pm
I just came across this post, and was wondering the same thing.  Is this something that netgraph could accomplish?  It seems like several people are doing this with AT&T fiber and opnatt.