OPNsense Forum
English Forums => Documentation and Translation => Topic started by: zyon on February 15, 2019, 07:10:56 pm
-
Hi all,
I have search but found nothing about bridge mode and OpenVPN...
Try all i have could be found but nothing help me, because always says open on AT but on bridge i have disabled my NAT.
OpenVPN work well (internet and connect to OPNsense) with my users.
Same question from a lot of poeple is my LAN(OPT1) access, sorry again to ask ...
All in "pass" but nothing.
Try a lot of time and used this : https://docs.opnsense.org/manual/how-tos/sslvpn_client.html
https://ibb.co/PZq7gZt
(https://ibb.co/PZq7gZt)
Same Tunnel Network 10.10.0.0/24 , my OPT1 Network 10.0.0.0/24
Add ACL to DNS, Push route to OpenVPN but nothing :s ...
If someone can help me ...
Thanks
(Sorry for my English)
-
You need to have OpenVPN in 'dev tap' mode to bridge with ethernet since a bridge is a layer 2 device.
Bart...
-
Thanks Bart ... not think to try that .... :-X
Sorry ^^
(Sorry for My English)
-
On Mobile connection get : TAP_NOT_SUPPORTED OSI layer 2 tunnels are not currently supported :s
And same on PC no lan :s... i don't understand
-
I'm afraid that is a known shortcoming of mobile platforms. It is fairly easy to run a TAP client on (x86) Linux though.
Which protocol do you require that needs a layer 2 connection? It is more efficient to run OpenVPN with 'dev tun' and it causes fewer issues, as you have found out.
Bart...
-
i don't know..
But TAP or TUN, no lan acces on bridge mode ...
I give up, I do not understand why.
I followed the documentations, try several times and same result everything is ok except access to the lan