Print Page - IPsec connected but no traffic

Title: IPsec connected but no traffic
Post by: maxxer on February 06, 2018, 09:51:24 AM

Hi. I'm new to OPNsense, I'm replacing an existing pfSense installation.

I replicated all the configurations and everything seems ok, I'm struggling a bit with VPNs.
Right now I'm trying to restore IPSect tunnels. Everything seems ok (from the status page), but I cannot reach the remote network. In Firewall > IPsec I've enabled all the traffic, just for testing.

From the status page the P2 is INSTALLED and Routed, but still I cannot ping any host of the remote endpoint, neither from the lan or from the firewall itself.

Any hint?
thanks

Title: Re: IPsec connected but no traffic
Post by: elektroinside on February 06, 2018, 10:42:27 AM

Hi and welcome to OPNsense!

There's some useful info here: https://docs.opnsense.org/manual/how-tos/ipsec-s2s.html
Maybe you'll find something there?

Title: Re: IPsec connected but no traffic
Post by: maxxer on February 06, 2018, 11:34:31 AM

Quote from: elektroinside on February 06, 2018, 10:42:27 AM
There's some useful info here: https://docs.opnsense.org/manual/how-tos/ipsec-s2s.html
Maybe you'll find something there?

thanks. I had seen that link, but I checked and I have done what it says. In fact the tunnel seems established!

Looks like a problem with the routes...

Title: Re: IPsec connected but no traffic
Post by: maxxer on February 06, 2018, 06:15:49 PM

Is it normal that the IPsec remote network is routed through the WAN gateway? This is what is shown in System > Routes > Status!

OPNsense Forum

Archive => 18.1 Legacy Series => Topic started by: maxxer on February 06, 2018, 09:51:24 AM