Hello!
I've searched with Google and looked through these forums but can't seem to get the right search in to get an answer on this so hoping you pros can help here.
I'm used to using Sophos and other firewalls and with those, in the event that a firmware fails to load or an SSD fails, the units can switch a backup USB or other device and load from there.
I'm trying to push my guys to what I think is the better route which is to have two OPNsense boxes and run high availability on them but I can't get them to see the light (and if this doesn't make sense, I'm happy to be corrected).
Anyway, wondering if this feature exists and/or if it does, how do I implement it? That is: in the event that the firmware on the main SSD fails, is there a way to get it to fail over to the USB?
In particular, my concern is that, in India, we have issues where the power randomly fluctuates or sometimes just straight up goes out. I worry that if that happens in the middle of an upgrade, we could run into an issue where the system can't boot and here I am, in the US, unable to get this firewall online (but, again, I'm seriously thinking that HA with two boxes makes sense here but wanna ask this anyway).
THANKS!!!
You could create a RAID1 with two SSDs and ZFS, you can configure that during install.
It will give you higher availability in case one drive fails completely, but if data corruption happens in unlikely cases that will write to both mirrored drives.
Two hardwares are way better.
Adding to Cedrik: ZFS is also way more resilient to frequent power failures than UFS, so even in case of a single boot device, use ZFS.