Hello.
I'm following this guide from the Tailscale KB to get OPNsense connected to my tailnet:
https://tailscale.com/docs/install/opnsense
I'm stuck on this part: https://tailscale.com/docs/install/opnsense#static-nat-port-mapping
It says to make these rules but I'm not seeing how I set source and destination ports to simply be "UDP" as I only see an option for setting a specific individual port or port range:
(https://tailscale.com/_next/image?url=%2F_next%2Fstatic%2Fmedia%2Fstatic-port-mapping.ce3201c0.png&w=640&q=75)
It also mentions an ACL change but I'm stumped on where I change that.
Any help would be greatly appreciated. Thank you! :)
It says on the link you
As of OPNsense v24.711, an os-tailscale community plugin is available.
It can be installed through the GUI. System > Firmware > Plugins. Check the box Show community plugins.
This plugin does not require any of the following command-line steps.
It's been a while but I just installed the plugin. I didn't do anything to NAT but I did set some firewall rules.
Quote from: opnsensehey on Today at 03:38:39 PMI'm not seeing how I set source and destination ports to simply be "UDP"
That might be outdated information since this can be done now : https://forum.opnsense.org/index.php?topic=52419.msg275740#msg275740
Read some posts before that one too if you want to know more about it ;)
Best is to watch the youtube videos of Sam Sheridan (author of the plugin)