WAN Interface on my Protectli v1210 fails to negotiate speed/duplex correctly when ISP coax is connected to cable modem, but does negotiate properly (2500/fdx) when I disconnect the ISP coax.
I'm fairly certain this is an ISP issue, but would appreciate some advice on how to collect meaningful information to help with ISP tech support
Setup
- Cox 2Gbps Internet
- Motorola SB8611 cable modem
- Protectli V1210, 2 Intel® I226-V 2.5Gigabit Ethernet NIC ports, RJ-45
- OpnSense 26.1.9
Issue
- WAN Interface fails to autonegotiate to 2500 and fails to get WAN IP (same issue if I hard configure 2500-t)
- Same issue with either interface (igc0 or igc1)
- Same issue with multiple cables
- Same issue with two different cable modems (Motorola SB861))
- Removing the ISP coax from cable modem, then WAN interface negotiates properly and receives default IP (192.168.100.x) from cable modem
- Factory reset / default OpnSense does not resolve nor does CMOS reset on Protectli
- Replacing OpnSense firewall with an older Asuswrt router (gt-ax6000) and the WAN interface on the router does negotiate properly to 2500/fdx and obtain WAN IP
Questions
1. Are there any interface settings and/or tunable I can configure to resolve this
2. What cli command can I run to help diagnose this + information I should capture to bring to ISP, so I can avoid the "simple" questions (change the cable, reset the router, ...)