I'm sure this has been covered before however trying to find the why searching for 'updat' or similar has returns a lot of results.
Curious as to why after I "Check for Updates" from the Firmware > Status, if I navigate to a different section - outside Firmware - in the FW, I must re "Check for Updates" again to reenter the update mode.
Can I trigger this manually?
If I subsequently click the Firmware > Updates tab, it shows there's an update, but does not enter the update mode.
I've tried clicking the release notes from Firmware > Changelog, but that too does not trigger the update mode.
It's not a major, just a funny mechanism - am I missing something?
EDIT: clarified issue