Hello,
I'm trying to get NUT setup with no luck. My goal is to setup NUT as Master in OPNsense and have my Unraid Server setup in client mode. After entering the information in the Nut: configuration and rebooting I have nothing showing in the UPS status tab.
Configuration setup:
Enable Nut: selected
Service Mode: Standalone
Name: APC
Listen Address: 127.0.0.1
UPS Type:
USBHID-Driver which I selected
I ran a couple commands in the shell with outputs below.
nut-scanner -U
Scanning USB bus.
[nutdev-usb1]
driver = "usbhid-ups"
port = "auto"
vendorid = "051D"
productid = "0002"
product = "Back-UPS XS 1300G FW:864.L8 .D USB FW:L8"
serial = "************"
vendor = "American Power Conversion"
# bus = "000"
# device = "002"
# busport = "004"
upsdrvctl start
Network UPS Tools - UPS driver controller 2.8.2
Network UPS Tools - apcupsd network client UPS driver 0.72 (2.8.2)
Error: UPS [APC] is for driver usbhid-ups, but I'm apcupsd-ups!
upsnotify: failed to notify about state 4: no notification tech defined, will not spam more about it
Driver failed to start (exit status=1).
It may look like i have an issue with the driver but I'm not certain. I did have apcupsd plugin installed but it has been removed.
How can I get working. Your help would be much appreciated.
Thanks